Menu

● NOT CONNECTED
Target —·ESP Wi-Fi picked.

Controllers

Hold a button to edit it.

Action Library

Import a board backup from LED Library or Servo Library, a shared remote from Remote Library, or a Playback bundle. Looks, moves, cues and buttons land here as actions you can link into controller buttons.

Cues

No cue steps yet — a step fires one of this controller's buttons.

Settings

Dark / Light

Send to your ESP32

Boards

Controllers fire at the active board only — linked multi-board firing is not in this app yet.

Playback link

Set by Playback when its export ships — until then Playback pieces are saved, not fired.

Download firmware Firmware v8.4 · gcp-prop-firmware.bin

  1. Download the firmware.
  2. Flash it to the new board at 0x0 with esptool: PORT=$(ls /dev/cu.usbserial-* | head -1); esptool --chip esp32 --port "$PORT" --baud 460800 write-flash 0x0 gcp-prop-firmware.bin
  3. Power the board, join its Wi-Fi (GCP-Prop-01), open its /setup page, name it (GCP-Prop-02…) and join your router if you use one.
  4. Back here: add the board in the boards list above.

Board

Add a piece

Button

No actions yet — add some below.

Slider

Add a switch action

GPIO 18 and 19 stay out of this list — they belong to the IR blaster and the IR eye.

Cue step

If the button plays an imported cue, the step waits for that cue to finish before the hold runs out.

Controller

Share downloads this controller plus only the actions its buttons use — importing that file adds it as a new controller.

Remove

Import controller

This controller uses these pins. Match them to your board:

The shared file isn't changed — pins are matched only in your copy.